Startup / Operation - BOMANN KS 163.1 Bedienungsanleitung

• Replace the appliance cover, which you have removed at
the beginning. Tight the screws and clip the screw covers
on.
• Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of the
door is ensured.
Reverse the freezer flap opening Reverse the freezer flap opening
Reverse the freezer flap opening Reverse the freezer flap opening
Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION CAUTION: : : :
CAUTION CAUTION
After transport, the appliance should be left standing upright for about 4 hours before connecting to the power
supply. Nonobservance could lead to malfunction of the cooling system and causes a breakdown of the appli-
ance.
Clean the interior of the appliance including all accessory parts located inside. Consider the instructions which
we provide in the chapter "Cleaning and Maintenance".
Starting the appliance Starting the appliance Starting the appliance Starting the appliance
• Switch on by connecting the appliance to the power supply.
• Operate the temperature control, which is located in the appliance interior. See also the following section
"Settings".
Settings Settings Settings Settings
Setting 0 means that the unit is in the off state. Turn the temperature control clockwise, starting from this set-
ting; the appliance will turn on automatically. The power levels 1 – 7 regulates the different values of the inter-
nal temperature. When opening the door, the interior light will turn on automatically.
Setting 0 off state
Setting 1 lowest setting (warmest inside temperature)
Setting 7 highest setting (coldest inside temperature)
• Open the freezer flap a little. Press the spring of the lower bracket up slightly
with a small screw-driver and remove the bracket incl. freezer flap.
• Place the blind cap (M) at the opposite side.
• Turn the freezer flap about 180° and press the lower flap bracket into the appro-
priated fixture of the freezer flap.
• Lift the freezer flap a little and fix it in the upper door bracket, at the same time
you press the lower door bracket in the square hole. Small adjustments to the
top and bottom will easily the mounting of the flap.

Startup / Operation

Startup / Operation Startup / Operation Startup / Operation
22