Installation - BOMANN KS 163.1 Bedienungsanleitung

Conditions for the installation location Condition Condition Condition s for the installation location s for the installation location s for the installation location
• Good ventilation is required around the appliance, in order to dissipate the heat properly and to guarantee
efficient cooling operation at low power consumption. Sufficient clearance must be created for this pur-
pose:
Gap to the back and to the side walls each approx. 5 cm;
-
Clearance to the front must be created so that the appliance door can open without being impeded.
-
• Only install at a location with an ambient temperature suitable for the climate class of the appliance. For
information on the climate class, please refer to chapter "Technical Data" or to the rating label located in
the interior or on the rear side of the appliance.
• Place the device on a steady and safe surface. If the device is not horizontally leveled, adjust the feet ac-
cordingly.
• Install the appliance for the wall socket to be freely accessible.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or any other heat sources;
-
at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be susceptible to cor-
-
rosion under such circumstances;
near volatile or flammable materials (e.g. gas, fuel, alcohol, paint, etc.) and in rooms which may have
-
poor air circulation (e.g. garages).
Electrical connection Electrical connection Electrical connection Electrical connection
WARNING: WARNING:
WARNING: WARNING:
• The installation to the mains supply must conform to the local standards and regulations.
• Improper connection may cause to an electric shock
• Do not modify the appliance plug. If the plug does not fit properly to the outlet, let install a proper outlet by
an authorized specialist.
• The accessibility of the power plug must be ensured in order to disconnect the appliance from the power
supply in case of an emergency.
CAUTION CAUTION CAUTION: : : : CAUTION
In case you disconnect the appliance or in case of power failure:
- Wait for approx. 5 minutes before restarting the appliance.
- Check the operation settings.
• Ensure that your mains power corresponds with the specifications of the appliance. The specifications are
printed on the rating label.
• Connect the mains cable to a properly installed and earthed wall outlet.

Installation

Installation
Installation Installation
electric shock!
electric shock electric shock
20