Operation With Vaporizer; De-Scaling Of The Vaporizer - EOS Bi-O-Tec Montage- Und Gebrauchsanweisung

Operation with vaporizer

(only Bi-O heaters)
The control of the vaporizer is managed by
the control unit. Either you receive a humi-
dity value which is regulated by a variance
comparison at the sensor or which is deter-
mined through a timing cycle.
Please note that the relative humidity varies
greatly due to the varying temperature dis-
tribution in the cabin. The readings of the
hygrometer and the readings at the control
unit can for that reason be very different.
Guarantee that suffi cient water is in the sto-
rage vessel
Never add essences, volatile oils or herbs
to the water; instead add these to the her-
bal bowl on the lid of the vaporizer.
These volatile oils which are released th-
rough action of the hot, rising steam are au-
tomatically distributed throughout the cabin
with the rising steam.
If the water supply in the vaporizer has been
drained, a buzzing signal indicates the wa-
ter storage. To continue your sauna session,
you have to refi ll the tank after a 5 minutes
stop of the sauna control or a changing to
Finnish sauna for 5 minutes.
The heating rod in the vaporizer must cool
down for 5 minutes before cold water is re-
fi lled.
Never pour water on the red-hot hea-
ting rod. Besides of the danger of
scald, the heating rod could be damaged.
Fill in the water up to the upper water level
marking.
Add herbs and essences to the
herbal bowl only.
By adding essences or any other
additives for air humidity, a health
hazard cannot be removed. It is advised
not to use those additives apart from the
recommended ones by the manufacturer
of the oven.
24
If additives are put in the water, this gene-
rally leads to a foamy boiling over of the wa-
ter. In this case the water must be drained
and the interior of the cold reservoir washed
out with a cloth soaked in alcohol or mineral
spirits. Even small remainders of essences
on the vaporizer wall will change the natural
molecular structure of the water.
Attention: Risk of scalding at the
steam outlet. Essences and herbs
are to be placed in the herb dish only.
Caution concerning control units with
post-heating phase.
the herbal bag in the herbal bowl during the
post-heating phase after a moist steam ses-
sion. These dry out rapidly in this case and a
present a fi re hazard!
For fi re safety reasons only herbs in perfora-
ted aluminium bags may be used.

De-scaling of the vaporizer

Consult your water utility company to deter-
mine the hardness level of your water. In
areas with hardness level 1 (0-8,4° Ger-
man hardness levels), the system generally
works without problems and must be de-
scaled only when necessary.
Should your water lie within the hardness
levels 2-3, the vaporizer must be de-scaled
from time to time (in accordance with the
hardness level).
To this end, add the de-scaling product for
household appliances, which is intended for
aluminium, to the water in the vaporizer in
accordance with manufacturer´s
tions. Bring the water-and-de-scaling pro-
duct mixture to a boil for about 10 minutes
and allow to cool. After cooling, drain the
mixture from the vaporizer and rinse at least
twice with clear water. Note also the instruc-
tions given by the de-scaling product manuf-
acturer.
GB
Never leave
instruc-