Further Safety Directions; Operation.startup - FLORABEST FKS 2200 B1 Betriebsanleitung

Fig. 1
• Kickback may occur when the nose or
tip of the guide bar touches an object, or
when the wood closes in and pinches the
saw chain in the cut
(cf. image 1/fig. B).
• Tip contact in some cases may cause
a sudden reverse reaction, kicking the
guide bar up and back towards the op-
erator (cf. image 1/fig. A).
• Pinching the saw chain along the top of
the guide bar may push the guide bar
rapidly back towards the operator.
• Either of these reactions may cause
you to lose control of the saw which
could result in serious personal injury.
Do not rely exclusively upon the safety
devices built into your saw. As a chain
saw user, you should take several steps
to keep your cutting jobs free from ac-
cident or injury.
Kickback is the result of tool misuse and/
or incorrect operating procedures or condi-
tions and can be avoided by taking proper
precautions as given below:
Maintain.a.firm.grip,.with.thumbs.
•
and.fingers.encircling.the.chain.
saw.handles,.with.both.hands.on.
the.saw.and.position.your.body.
and.arm.to.allow.you.to.resist.
kickback.forces. Kickback forces can
be controlled by the operator, if proper
precautions are taken. Do not let go of
the chain saw.
Do.not.overreach.and.do.not.cut.
•
above.shoulder.height..This helps
prevent unintended tip contact and ena-
bles better control of the chain saw in
unexpected situations.
Only.use.replacement.bars.and.
•
chains.specified.by.the.manufac-
turer..Incorrect replacement bars and
chains may cause chain breakage and/
or kickback.
Follow.the.manufacturer´s.sharp-
•
ening.and.maintenance.instruc-
tions.for.the.saw.chain..Decreasing
the depth gauge height can lead to
increased kickback.

Further safety directions

• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
• Lay the extension cable in such a way
that it will not be caught by branches
or similar during sawing.
• Use a surge protector with a release cur-
rent of 30 mA or less.
• Comply carefully with maintenance,
control and service instructions in
this manual. Damaged protective de-
vices and parts have to be repared or
changed except as noted otherwise in
this manual.
Operation startup
. Always.wear.protective.
gloves.when.working.with.
the.chainsaw.and.employ.
only.original.parts..Pull.out.
the.power.plug.before.doing.
any.work.on.the.chainsaw.
itself.-–.injury.hazard!
GB
57