Boiling Water - Silvercrest SWK 3000 EDS B2 Bedienungsanleitung

Boiling water

RISK - ELECTRICAL SHOCK!
Never place the electrical base 3 close to water – this would be a
►
potentially fatal risk!
WARNING - RISK OF INJURY!
► Always use freshly drawn water. Do not consume any water that has
already stood in the kettle for longer than one hour. Do not reboil water
that has cooled down. Always pour old water away. Microbes could have
formed in it!
NOTE
Always ensure that the ON/OFF switch 2 is turned to " " when the mains
►
plug is unplugged and the device is standing on the base 3.
If not, the device could heat up unintendedly as soon as the mains plug is
plugged in again.
1) Lift the kettle off of the base when fi lling it!
2) Press the unlocking button 1 and open the lid.
NOTE
► When fi lling it, hold the kettle upright. This is the only way to read the
markings on the scale 5 correctly.
3) Fill the kettle...
–
–
4) First close the lid, then place the kettle on the base 3, so that it sits securely
on the base 3.
5) Now insert the plug into the mains power socket.
6) Press the ON/OFF switch 2 downwards so that it engages.
WARNING - RISK OF INJURY!
► For safety reasons you should not open the lid when the water is boiling or
extremely hot. There is a risk of scalding.
7) The control lamps integrated into the scale 5 as well as the control lamp in the
ON/OFF switch 2 indicate that the appliance is now heating up.
8) As soon as the water is boiling, the appliance will switch itself off , the
ON/OFF switch 2 clicks upwards and the light goes out.
SWK 3000 EDS B2
to at least the MIN mark, so that the appliance does not overheat,
to maximum the MAX mark, so that boiling water cannot spill out.
GB
31