Preparation; Unpacking; Disposal Of The Packaging; Initial Use - Silvercrest SWK 3000 EDS B2 Bedienungsanleitung

Preparation

Unpacking

GB

Disposal of the packaging

Initial use

30
♦
Remove all components of the appliance and the operating manual from
the carton.
♦
Remove all packing material.
The packaging protects the appliance against transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material and
reduces the amount of waste generated. Dispose of packaging material that is
no longer needed according to the regionally established regulations.
NOTICE
► If possible, preserve the appliance's original packaging during the warranty
period so that, in the event of a warranty claim, you can pack the appliance
ideally for its return.
WARNING - RISK OF INJURY!
► Always and only use freshly drawn mains water in the kettle! Do not con-
sume any water that is not certifi ed as potable. If you do, you are taking a
risk with your health!
Before starting the appliance up, make certain that ...
– the appliance, plug and power cable are in a serviceable condition
and ...
– all packaging materials have been removed from the appliance.
1) Open the lid by pressing on the release button 1.
2) Fill the appliance with water up to the MAX marking and let it come to a
full boil once – as described in the next section.
3) After it has boiled, pour this water away.
4) Rinse the kettle out with clear water.
5) Fill the appliance with water once again, up to the MAX marking, and
then bring it to boil. When done, pour this water away also.
The appliance is now ready for use.
SWK 3000 EDS B2