Commissioning; Switching On And Off; Working Instructions; Grinding Surfaces - Parkside PEXS 270 A1 Originalbetriebsanleitung

... / ... / Working instructions / Maintenance and Cleaning / Service centre
adapter for external exhaust suction
the reducing piece if necessary
Removal:
P ull the hose of the suction device off the
adapter for external exhaust suc-tion
T urn the adapter for external exhaust suction
in an anticlockwise direction and pull it off with
the reducing piece

Commissioning

Q

Switching on and off

Q
Note! Always switch the rotary sander on before
applying it to the material to be worked, then make
contact with it.
When operating the device you can select between
intermittent or continuous operation mode:
To switch on intermittent operation mode:
P ress the oN / oFF switch
To switch off intermittent operation mode:
R elease the oN / oFF switch
Switching on continuous operation:
P ress the oN / oFF switch
down and press the locking button
Switching off after sustained operation:
P ress the oN / oFF switch

Working instructions

Q
W ait until the electric tool has stopped moving
before you put it down.

Grinding Surfaces

Q
T urn the electric tool on, place the entire grinding
surface on the substrate that is to be worked
on and move it with moderate pressure across
the workpiece (see Illustration B, C, D).
26 GB
, using
7
.
8
.
7
if necessary.
8
.
1
.
1
, keep it pressed
1
.
2
and then release it.
1
Note: The rate of metal removal and the
grinding pattern are essentially determined by
the grinding disc that has been selected and
the grinding pressure. only grind-ing discs that
are in perfect condition will provide good
grinding performance.
P lease ensure that the grinding pressure is
7
even. An excessive increase in the grinding
pressure leads not only to a higher rate of met-
al removal, but also greater wear and tear on
the grinding disc.
Y ou should not use a grinding disc that has
been used for working metal for other materials.

Maintenance and Cleaning

Q
The rotary sander is maintenance free.
C lean the appliance regularly, preferably direct-
ly on completion of the task.
U se a dry cloth to clean the device. Under no
circumstances should you use petrol, solvent or
cleaners which attack plastic.
K eep the ventilation openings clear at all times.
R emove dust clinging to the sander with a brush.

Service centre

Q
repaired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
lead needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
Note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.
Have your device
If the plug or mains