Rs-232, Serial Control Input - WolfVision VZ-C32 3 Bedienungsanleitungen

RGB Port
The EXTERN input (#14) has the same pin assignment as the RGB output (#12 and #16).
5 1
15 11
15-pin D-Sub HD
connector female
(front side, unit)
The output level on VGA and Preview output can be adjusted to match exactly 700mV. This can be helpful
to balance different image brightness i.e. when using external input.
For exact adjustment, please use external measurement equipment.
Range: 85% to 100% (on-screen extra menu - see page 16)
External Input - EXTERN
A computer can be connected to the External RGB input (#14) of the Visualizer.
By pressing the EXTERN key (#33) the Visualizer displays the signal from the external input to the
audience. To switch back to the live image of the Visualizer use the VZ key (#27).
The Visualizer can be used for a "Live Picture to External Picture Comparison" on two monitors or beamers.
While one monitor or beamer displays the signal of the external source and the other displays the live image
of the Visualizer.
The settings of the Visualizer can be changed in the on-screen menu (see page 16).
The Visualizer has a built-in A/D-converter in order to digitize the analog RGB signal from the computer and
output it on the RGB and DVI outputs in the selected signal format.
Preferred resolution is:
Supported resolutions from VGA (640x480@60Hz) to WXGA+ (1440x900@60Hz) with several resolutions
and refresh rates in this range.
Following data are provided:
Plug & Play Monitor VESA DDC
Monitor name: "WolfVision"
Video Input Definition: Analog at 0.7Vpp and separated synchronization signals
Vertical range limits: 48Hz - 86Hz
Horizontal range limits: 30kHz - 121kHz
Maximum pixel clock: 170MHz
Gamma: 2.2
Preferred resolution: SXGA- (1280x960) @60Hz

RS-232, Serial Control Input

The serial port (#20) can be used to control the Visualizer through an external device, such as a room
control system that is used to integrate conference rooms.
1 5
6 9
9-pin D-Sub connector
on unit male
(front side)
The complete serial protocol can be found on our internet website under: www.wolfvision.com/support
1 - Analog Red video
2 - Analog Green video
3 - Analog Blue video
4 - N/C Not connected
5 - GND Ground
SXGA- (1280x960) @60Hz
Pins: 2: RX, 3: TX, 5: GND
Baud Rate: 9200, 19200, 38400, 57600 or 115200 (selectable)
databits: 8, stopbit: 1, parity: no
The baud rate can be changed in the on-screen extra menu by keeping pressed the
MENU key until the extra menu appears (see page 16).
6 - Red return
7 - Green return
8 - Blue return
9 - SENSE +5 V DC from Visualizer
10 - GND Ground (VSync, DDC)
15
11 - N/C Not connected
12 - SDA I²C data
13 - HSync Horizontal sync
14 - VSync Vertical sync
15 - SCL I²C clock