Operating Elements; Before Commissioning; Operation - Kärcher BRS 40/1000 C Bedienungsanleitung

1 Brushing rollers
2 Button for brush change
3 Bearing wheel
4 Strain relief clamp
5 Push handle
6 Switch for detergent solution
7 Switch for brush drive
8 Support of the transport wheel
9 Mains plug
10 Lock of pushing handle
11 Fresh water tank cover
12 Fresh water tank
13 Park support
14 Release button for the transport wheel
Colour coding
– The operating elements for the cleaning
process are yellow.
– The controls for the maintenance and
service are light gray.
10

Operating elements

Before Commissioning

Installing the pushing handle
ATTENTION
Risk of damage. Do not open cable loops
during assembly.
 Slide the lock of the push handle up.
 Place the lower push handle vertically
and arrest.
 Slide the upper slider half onto the low-
er slider half.
 Insert the screw into the star handle and
tighten it.
2
-
EN
 Attach the cable to the wire hook on the
push handle.
Installing the Brushes
The brushes must be installed before the
initial operation (see "Maintenance works").

Operation

Note:
To put the brush drive out of operation im-
mediately release the brush drive switch.
Filling in detergents
WARNING
Risk of damage. Only use the recommend-
ed detergents. With other detergents, the
operator bears the increased risk regarding
the operational safety, risk of accident and
reduced service life of the appliance. Only
use detergents that are free of solvents, hy-
drochloric acid and hydrofluoric acid.
Follow the safety instructions for using de-
tergents.
Note:
Do not use highly foaming detergents.
Recommended detergents:
Application
Routine cleaning of all water
resistant floors
Routine cleaning of glossy
surfaces (e.g. granite)
Routine cleaning and basic
cleaning of industrial floors
Routine cleaning and basic
cleaning of fine stoneware
tiles
Detergent
RM 746
RM 780
RM 755 es
RM 69 ASF
RM 753