Operation - Cameo CLSCAN80W Bedienungsanleitung

8
SECURING LUG
Eyelet for safety rope. Overhead installation may only be carried out by qualified personnel. The spotlight must be fitted with a suitable
safety rope to ensure that it does not fall down.
NOTE: The housing holds the lens for focusing the projector at various distances. A ridged rim ensures improved grip (turn in a clockwise
direction = far range, turn in an anti-clockwise direction = close range).

OPERATION

A few seconds after connecting to the mains, the spotlight is ready for operation and the previously selected operating mode is activated.
CONFIGURE DMX START ADDRESS
Press the MODE button repeatedly until "Addr" appears in the display. Now press ENTER and configure the DMX start address using the UP
and DOWN buttons as required (A001–A512). Confirm your entry by pressing ENTER. Synchronous control of several spotlights of the same
model with a DMX controller (e.g. DMX console) can be achieved by configuring the lights with the identical DMX starting address and the
same DMX mode setting, and with the help of DMX cables.
-> ENTER -> UP/DOWN
DMX MODE SETTING
Press the MODE button repeatedly until "ModE" appears in the display. Now press ENTER and use the UP and DOWN buttons to select
"ChAn". Confirm with ENTER and select the desired DMX operating mode using the UP and DOWN buttons (9Ch, 12Ch). Confirm your entry
by pressing ENTER. To activate the DMX operating mode, confirm the DMX address as described above. Tables with the channel assignment
of the DMX modes can be found in these instructions under DMX CONTROL.
-> ENTER -> UP/DOWN
SLAVE MODE
Press the MODE button repeatedly until "ModE" appears in the display. Then press ENTER and use the UP and DOWN buttons to select
"SLAV". Connect the slave and the master units (same model) with a DMX cable, and enable one of the standalone modes on the master
unit (AUTO, SOUND). The slave unit will now follow the master unit.
-> ENTER -> UP/DOWN
AUTOMATIC CONTROL MODE (AUTO)
Select one of the 13 different auto programmes (Au00–Au12) and configure the programme running speed (SP01–SP99). Press the MODE
button repeatedly until "ModE" appears in the display. Now press ENTER and use the UP and DOWN buttons to select "AUto", then confirm
again with ENTER. Use the UP and DOWN buttons to select "Au__", then confirm with ENTER. Now you can select the desired programme
by using the UP and DOWN buttons. Confirm by pressing ENTER. You can set the programme run speed by using the UP and DOWN buttons
to select "SP__", confirming with ENTER and then setting the desired value, from 01 to 99, with the UP and DOWN buttons (01 = minimum
speed, 99 = maximum speed). Confirm by pressing ENTER. If no further commands are entered, the display will show the programme
number after about 10 seconds.
-> ENTER -> UP/DOWN
6
-> ENTER
-
<- MODE
-> ENTER -> UP/DOWN
-> ENTER
<- MODE
/
-> ENTER -> UP/DOWN
-> ENTER
/
<- MODE
-> ENTER -> UP/DOWN
-> ENTER -> UP/DOWN
-> ENTER
-
<- MODE
-> ENTER
-
<- MODE