What To Do If - IKEA LAGAN Gebrauchsanleitung

ENGLISH
5. Loosen the
drainage
channel
from its rest-
ing position
at the bot-
tom of the
appliance,
push it in ac-
cording to
the illustration and put a bowl under
the outlet where you can collect the
water.
6. Carefully scrape off the ice when it
starts to thaw. Use the provided plastic
scraper.
7. When all the ice has melted, clean and
wipe the cabinet dry, then put the
drainage channel back in place.
8. Switch on the appliance.
9. Reload the previously removed food in-
to the compartments.
Important! Let the appliance run on the
highest settings for some hours so that it can
reach the sufficient storing temperature as
soon as possible.

What to do if...

Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent
person must do the troubleshooting that is
not in this manual.
Problem
The appliance is noisy.
The appliance does not
operate. The lamp does
not operate.
Possible cause
The appliance is not suppor-
ted properly.
The appliance is switched off. Switch on the appliance.
The plug is not connected to
the mains socket correctly.
The appliance has no power.
There is no voltage in the
mains socket.
Warning! Never use sharp metal tools
to scrape off frost from the evaporator
as you could damage it. Do not use a
mechanical device or any artificial means to
speed up the thawing process other than
those recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1. Disconnect the appliance from electrici-
ty supply.
2. Remove all food.
3. Defrost, if foreseen
4. Clean the appliance and all accesso-
ries.
5. Leave all doors open to prevent un-
pleasant smells.
If the cabinet will be kept on, ask somebody
to check it once in a while to prevent the
food inside from spoiling in case of a power
failure.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Solution
Check if the appliance stands
stable (all the feet should be
on the floor).
Connect the plug to the mains
socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
13