Operation; Stand Alone Operation; Master/Slave Operation; Control Board - EuroLite LED TMH-60 MK2 Bedienungsanleitung

OPERATION

After you connected the effect to the mains, the EUROLITE LED TMH-60 MK2 starts running. During the
Reset, the motors are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the LED TMH-60 MK2 can be used without controller.
Disconnect the LED TMH-60 MK2 from the controller and call the internal program. Please refer to the
instructions under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT jack with the DMX IN plug of the next device.
Set the desired Master-mode - „Automatic program mode" or „Sound controlled mode" - for the master-
device. Set the DMX address 1 for all slave-devices.

Control Board

The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or make a reset.
The main menu is accessed by pressing the Mode/Esc-button.
Browse through the submenu by pressing Up or Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down.
UP
MODE/ESC
Confirm every selection by pressing the Enter-button.
You can leave every mode by pressing the Mode/Esc-
button. The functions provided are described in the
following sections.
DOWN
ENTER
27/35 00084433, Version 1.0