Operation; Stand Alone Operation; Call Up The Internal Program; Dip Switch: Function - EuroLite TW-150 Bedienungsanleitung

The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the TW-150 starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.

Stand Alone operation

In the Stand Alone mode, the TW-150 can be used without controller. You can do without a controller as the
TW-150 features a built-in microphone, which provides automatic sound control.
Disconnect the TW-150 from the controller and set all DIP-switches to Off.
The lamp is automatically ignited as soon as the condensor microphone receives music signals.

Call up the internal program

In order to call up the internal program, set DIP-switches No. 9 and 10 to On.
DIP Switch: Function:
9 + 10 Auto program
10 Auto sound control
10 + 1 Shutter open/white
10 + 2 Shutter open /cyan
10 + 2 + 1 Shutter open /yellow
10 + 3 Shutter open /violet
10 + 3 + 1 Shutter open /green
10 + 3 + 2 Shutter open /orange
10 + 3 + 2 + 1 Shutter open /blue
10 + 4 Shutter open /pink
10 + 4 + 1 Shutter open /rainbow with slow speed
Master/Slave-operation
Connect the master and slave-devices as desribed above and set the DIP-switches accordingly.
Please note: If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.
International
L
N
26/52 51785866_V_1_0.DOC