Operation; Remote Control; Switching On/Off; Inserting A Cd - Omnitronic XDP-1400 Bedienungsanleitung

6 OPERATION

The XDP-1400 can either be operated via the buttons on the front panel or via the remote control.
However, via the remote control it is not possible to browse the folders on a CD or a storage medium.

6.1 Remote control

1 When actuating a button, always direct the remote control towards the sensor. The must be no obstacles
between remote control and the sensor.
2 If the range of the remote control decreases, the batteries are probably exhausted and must be replaced.

6.2 Switching on/off

1 Switch on the XDP-1400 with the power button. The unit will automatically detect if a CD is inserted
(indication "READING"). If a CD is inserted, the display will shortly indicate the total number of titles and
the total remain time followed by information concerning the first title after the read-in. If no CD is
inserted "NO DISC" will be displayed.
2 Prior to switching the unit off, always terminate the playback with the button
press the power button to switch off the unit.

6.3 Inserting a CD

1 To insert a CD, open the CD tray with the button
2 Insert the CD with the lettering facing upwards and close the CD tray again with the button
display will show "CLOSE". The control LED lights during the read-in.

6.4 Loading and removing USB devices and memory cards

1 Insert USB devices into the USB port.
2 Insert SD cards with the contacts pointing downwards and the notched corner to the left so far into the
card slot until it engages.
3 To eject a memory card, slightly press the card in until it comes out and can be removed.
CAUTION! Never attempt to remove USB devices or memory cards in play mode. Otherwise
damage or loss of data may occur.
Regarding USB storage devices
• This unit supports MSC (Mass Storage Class) USB storage devices 1.0, 1.1, 2.0 including
external portable flash memory devices and digital audio players. However, hard discs, optical
discs such as external CD/DVD drives, and USB devices connected to a USB hub will not be
recognized.
• Depending on the device used, proper playback may not be possible with all USB storage
devices.
• When connecting a USB device with a large number of folders and files, some time may be
required to read in the contents.

6.5 Selecting USB devices and memory cards

To switch from the CD to a USB device or a memory card, press the selector switch CD/USB/SD. The unit
must be in pause mode. The LEDs will verify which source is active.
1 The first long actuation of the button will select the USB port. After the read-in (indication "READING
USB") the total number of titles will be shortly displayed. Afterwards information concerning the first title
will follow. If no device is inserted "NO USB" will be displayed.
2 The next long actuation of the button will select the SD card slot. After the read-in (indication "READING
SD") the total number of titles will be shortly displayed. Afterwards information concerning the first title
will follow. If no card is inserted "NO SD" will be displayed.
3 The next long actuation of the button switches the unit back to the CD.
(control LED lights). The display will show "OPEN".
28/32
or the button . Then
. The
00047148.DOC, Version 1.0