Operation; Switching On/Off; Inserting A Cd; Loading And Removing Usb Devices And Memory Cards - Omnitronic XDP-2800MT Bedienungsanleitung

6. OPERATION

The operation of the two players is identical.

Switching on/off

1
Switch on the XDP-2800MT with the
power button.
• The unit will automatically detect if a CD is
inserted (indication "READING").
• If a CD is inserted, the display will shortly
indicate the total number of titles and the
total remain time followed by information
concerning the first title after the read-in.
• If no CD is inserted "NO DISC" will be
displayed.
2
Prior to switching the unit off, always
terminate the playback with the button [►II]
or the button []. Then press the power
button to switch off the unit.

Inserting a CD

1
To insert a CD, open the CD tray with the
button [ ].
• The control LED lights.
• The display will show "Open".
2
Insert the CD with the lettering facing
upwards and close the CD tray again with
the button [ ].
• The display will show "CLOSE".
• The control LED lights during the read-in
Loading and removing USB devices
and memory cards
1
Insert USB devices into the USB port.
• To remove a USB device, disconnect it from
the USB port.
2
Insert a memory card with the contacts
pointing downwards and the notched corner
to the left so far into the card slot until it
engages.
• To eject a memory card, slightly press the
card in until it comes out and can be
removed.
3
Prior to removing a storage medium, always
terminate the playback with the button [►II]
or the button []. Otherwise damage or loss
of data may occur.

Regarding data carriers
• This unit supports data carriers with the file
system FAT32 and with a capacity up to 32
GB.
• This unit supports MSC (Mass Storage Class)
USB storage devices 1.0, 1.1, 2.0 including
external portable flash memory devices and
digital audio players. However, hard discs,
optical discs such as external CD/DVD drives
will not be recognized. Depending on the
device used, proper playback may not be
possible with all USB devices.
• This units supports SD(HC) and MMC memory
cards.
• If a data carrier is not recognized at the first
try, remove it and insert it again.
Selecting USB devices and memory
cards
To switch from the CD to a USB device or a
memory card,
CD/USB/SD.
• The unit must be in pause mode.
• The LEDs will verify which source is active.
1
The first long actuation of the button will
select the USB port.
• After the read-in (indication "READING
USB") the total number of titles will be shortly
displayed. Afterwards information concerning
the first title will follow.
• If no device is inserted "NO USB" will be
displayed.
2
The next long actuation of the button will
select the memory card slot.
• After the read-in (indication "READING SD")
the total number of titles will be shortly
displayed. Afterwards information concerning
the first title will follow.
• If no card is inserted "No SD" will be
displayed.
3
The next long actuation of the button
switches the unit back to the CD.

Selecting the operating mode

In continuous play mode, all titles of are played
one after the other. Press the button SINGLE to
switch to single title play. Then the unit is set to
pause at the start of the next title after playing a
title and indicates "SINGLE".
33/38
press the selector
00075258.DOC, Version 1.0
switch