Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6 OPERATION
The XMP-1400 can either be operated via the buttons on the front panel or via the remote control.
However, via the remote control it is not possible to browse the folders.
6.1 Remote control
1
When actuating a button, always direct the remote control towards the sensor. There must be no
obstacles between remote control and the sensor.
2
If the range of the remote control decreases, the batteries are probably exhausted and must be replaced.
6.2 Switching on/off
1
Switch on the XMP-1400 with the power button. The unit will automatically detect if a CD is inserted
(indication "READING"). If a CD is inserted, the display will shortly indicate the total number of titles and
the total remain time followed by information concerning the first title after the read-in. If no CD is
inserted "NO DISC" will be displayed.
2
Prior to switching the unit off, always terminate the playback with the button
press the power button to switch off the unit.
6.3 Inserting a CD
1
To insert a CD, open the CD tray with the button
2
Insert the CD with the lettering facing upwards and close the CD tray again with the button
display will show "CLOSE". The control LED lights during the read-in.
6.4 Basic settings
After switching on, continuous play and elapsed title time (indication "ELAPSED") will be active as basic
settings. These settings can be changed.
6.4.1 Selecting the operating mode
In the basic setting continuous play, all titles of are played one after the other and the unit stops at the end of
the last title. Press the button SINGLE on the player or the button SGL/CTN on the remote control to switch
to single title play. Then the unit is set to pause at the start of the next title after playing a title and indicates
"SINGLE".
6.4.2 Switching over the time indication
1
As a basic setting, the display will show the elapsed time of the current title (indication "ELAPSED"):
• numerically in minutes, seconds and frames (1 frame = 1/75 second)
• graphically by the length of the bargraph. The longer the replay time, the more segments the bargraph
will have. The last 12 seconds of a title are indicated by the bargraph flashing in its full length.
2
Press the button TIME to switch over the time indication to remaining title time (indication "REMAIN").
The number of segments of the bargraph will be reduced with increased playing time.
3
To return to basic setting, press the button TIME once again.
6.5 Selecting a title
1
For selecting titles use the control FOLDER/TRACK SEARCH. Turn the control once to the left to select
the next lower title or to the right to select the next higher title. Title number and title name are indicated
in the text line.
2
With the buttons
time the button
is pressed, the unit will advance one title. By pressing the button
the beginning of the title and with each further actuation, the unit will go back another title.
3
By pressing the button +10, the unit will advance 10 titles.
and
you can skip one title or several titles in forward or backward direction. Each
(control LED lights). The display will show "OPEN".
27/30
or the button
. Then
. The
, the unit will go to
00047149.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
