Operation; Unlock Program Mode; Switch The Dimmer Display; Memorize Scenes - EuroLite DMX SCENE SETTER Bedienungsanleitung

6. OPERATION

After you connected the device to the mains, the DMX Scene Setter is ready for use.

Unlock program mode

Before you can start programming you need to unlock the program mode.
Press and hold the Record-button.
Press the Flash-buttons 1, 5, 6, 8 in Preset A.
Release the Record-button.
The red LED above the Record-button is lit again and the program mode is unlocked.
2 x 12 channel Preset
With the Scene Setter you can adust two different scenes in Preset A and Preset B and fade from one to
another via the master-faders.
Press the Mode Select-button, until the A Double/Preset B-LED is lit.
Push Master A-fader to maximum.
Push channel-faders in Preset A to the desired setting.
Pull the Master B-fader to maximum.
Push channel-faders in Preset B to the desired setting.
Fade from Preset B to Preset A by pushing Master A-fader.
In Double Preset-mode, the buttons over the master faders can be used as Flash-buttons.

Switch the dimmer display

The dimmer display can be switched from percent to the DMX-value:
Press and hold the Record-button.
Press the Insert-button and the display switched to the DMX-value (0-255).
In order to switch the display back to percent, repeat the procedure.

Memorize scenes

With the Scene Setter you can memorize up to 48 different scenes with 24 channels (Page 1 to Page 4).
Press the Mode Select-button, until the 1-24 Single/Preset Park-LED is lit.
Push the Master A-fader to maximum.
Push channel-faders to the desired setting.
Press the Record-button.
Press and hold the Record-button and press the desired Flash-button in Preset B.
The scene is now memorized on this fader.
Call up scenes
Press the Mode Select-button, until the Chase/Scenes-LED is lit.
Pull all channel-faders to minimum.
Push the Master A-fader to maximum.
Push the channel-fader of the desired scene in Preset B to maximum.
The scene will be called up.

Memorize chasers

With the Scene Setter you can memorize up to 48 different scenes with 24 channels (Page 1 to Page 4).
Press the Mode Select-button, until the 1-24 Single/Preset Park-LED is lit.
Push the Master A-fader to maximum.
Push channel-faders to the desired setting.
Press the Record-button.
Push channel-faders to the desired setting for editing the next scene and press the Record-button.
Memorize as many scenes as desired or until the maximum (999 scenes) is reached.
Press and hold the Record-button and press the desired Flash-button in Preset B.
The scene is now memorized on this fader.
21/26 70064540_V_2_1.DOC