Setup; Before Use; Installing Illuminants - EuroLite BLN-10 Bedienungsanleitung

Before use

Remove any packing material and unroll the light chain.

Installing illuminants

Danger of electric shock! Always disconnect the light chain from the mains socket prior to installing or
replacing a lamp.
The device is supplied without bulbs. You may use commercially available lamps with E-27 sockets up to 25 watts.
Matching bulbs are indicated in the "Accessories" section.
Proceed as follows:
Step 1: Disconnect the light chain from the mains.
Step 2: Carefully pull the rubber seal downward from its original position (fig. 1) to position 2 (fig. 2).
Step 3: Turn counterclockwise to remove the defective lamp from the holder. Then carefully screw in the
replacement lamp into the holder. If you feel any resistance remove the bulb to check why there is
resistance. Make sure the contacts are in the correct position. One must be flat in the bottom and one
must be straight up (fig 3).
Step 4: Pull up the rubber seal again (fig. 5). Make sure it is not crinkled against the bulb.
Fig. 1
Fig. 3
Fig. 5

SETUP

DANGER!
Fig. 2
Fig. 4
Fig. 6
10 • EN