Holzmann TS 250FL Bedienungsanleitung Seite 27

8.4 OFF switch assembly
Abb. 11
8.5 Installation extra table
Unscrew the eight M8x30 - the side screws in the threaded holes provided so that each
stands out about 10mm.
Now hang the extra slots in the table with the eight screws.
Tighten the eight screws and note that the extra table should be mounted on the same level
as the main table is.
Never lift the table without help! Always look for the right or retained Hey!
8.6 Front rail assembly
To mount the front rail following things are needed:
Four M8x25 screws
Four 8mm washers
Four M8 self-locking nuts
Screw the rail at the head table as per the sketch and make sure that the rail is parallel
with the table.
8.7 Installation of the fence
Screw the handle clockwise to the head of the ruler.
Screw the head and the ruler with two M8 hex bolts 12.
Hang the head of the ruler in the front rail.
Now move the fence in the leadership on and off, with a distance of about 2mm between the
head and front rail should be.
If the ruler is not smoothly glide, be readjusted by loosening the front is set to true concurrency.
The fence can be fixed to the desired position by a lever down.
8.8 Blade guard assembling
Install the blade guard (a) on the wedge (b).
8.9 Connection of the extraction
There are two suctions for connection to a dust collector provided. A suction side of the housing is
located on the other blade guard. Supplied with the thin suction hose connection between the
HOLZMANN Maschinen Austria
Plug the supplied gasket into the recess provided for it at the counter and
screw the switch on the casing of the machine with 4 M4x60 screws.
A T T E N T I O N
Abb. 12
Abb. 13
www.holzmann-maschinen.at
Abb. 14
Abb. 15
Seite 27
Formatkreissäge TS 250FL