B) Verification Of The Drive Function; C) Verification Of The Switching Function - ModelCraft GT3 Bedienungsanleitung

b) Verification of the Drive Function

When you move the operating lever for the
drive function (see figure 1, item 4) towards
the handle to the stop, the model must ac-
celerate (see figure 15, sketch A).
If you press the operating lever forwards,
the model must decelerate or switch to re-
verse driving (see figure 15, sketch B).
If the driving function responds exactly opposite to the steering direction on the transmitter, this can be
easily reprogrammed. For the exact procedure, refer to the following chapter "Programming the Remote
Control", section "Servo Reverse Function (REV)".

c) Verification of the Switching Function

If you press the operating switch for channel 3 (see figure 1, item 3), the servo
connected to receiver output 3 (CH3) must move from one end position to the
other.
The respective rotational direction and rotational angle can be set individually
later when programming the remote control.
52
Figure 15
Figure 16