System Options - testo 560 Bedienungsanleitung

S S y y s s t t e e m m
o o p p t t i i o o n n s s
A A u u t t o o m m a a t t i i c c
S S w w i i t t c c h h - - o o f f f f
S S w w i i t t c c h h - - o o f f f f
i i n n : : 1 1 0 0 m m i i n n
S S y y s s t t e e m m
o o p p t t i i o o n n s s
R R e e f f r r i i g g . . s s y y s s t t e e m m
H H e e a a t t p p u u m m p p
S S y y s s t t e e m m
o o p p t t i i o o n n s s
T T e e m m p p e e r r a a t t u u r r
O O f f f f s s e e t t
E E x x t t . . S S e e n n s s o o r r
C C a a s s i i n n g g
S S e e n n s s o o r r O O f f f f s s e e t t
0 0 . . 1 1 2 2 4 4 . . 4 4

5.3.12 System options

After each procedure has been completed, the
the last measurement screen. The settings made in the
o o p p t t i i o o n n s s
are retained until a further change is made.
Automatic switch-off
The factory setting is 10 minutes. If
automatic switch-off is deactivated.
1 Select
S S y y s s t t e e m m o o p p t t i i o o n n s s
selection with .
A A u u t t o o m m a a t t i i c c S S w w i i t t c c h h - - o o f f f f
2 Select
the selection with
3 Adjust the desired switch-off time with
selection with .
Refrigerating system or heat pump
This selection determines the calculation of the theoretical cap.-
value for a refrigerating system or a heat pump.
The heat-cap.-value of a system is always 1 higher than its cold-
cap.-value.
1 Select
S S y y s s t t e e m m o o p p t t i i o o n n s s
selection with .
2 Select
R R e e f f r r i i g g . . s s y y s s t t e e m m H H e e a a t t p p u u m m p p
3 Choose between
or and confirm the selection with
Temperature sensor calibration
A correction factor for the connected temperature sensor or the
integrated temperature sensor can be entered here. To reset the
offset to the factory setting, choose
1 Select
S S y y s s t t e e m m o o p p t t i i o o n n s s
selection with .
2 Select temperature offset with
selection with .
3 Select
E E x x t t . . S S e e n n s s o o r r
the selection with
4 Select the desired offset value with
selection with .
0 0 0 0 m m i i n n
with or
with
.
with or
R R e e f f r r i i g g . . s s y y s s t t e e m m
and
0 0 . . 0 0
.
with or
or
C C a a s s i i n n g g
or with
.
5. Operation
testo 560
returns to
S S y y s s t t e e m m
is selected, the
and confirm the
or and confirm
or and confirm the
and confirm the
with or .
H H e e a a t t p p u u m m p p
with
.
and confirm the
and confirm the
or and confirm
or and confirm the
19