Maintenance - Helo FUSION Gebrauchsanweisung

2.9.

Maintenance

Sauna heater
There may be chalky remains from the water on the sauna heater surface. Clean it with a cleaning and
care solution for rst fixtures.
Water tank
The tank should be drained after every use. This reduces the amount of chalky remains accumulating on
the inner surface of the tank. The tank is drained as follows (see image):
1. Release the draining hose from its brackets (under the tank).
2. Let the draining hose dangle freely.
3. Put a container with a capacity of at least 5 litres under the draining hose.
4. Open the draining hose tap and let the tank drain.
If the tank is drained immediately after bathing, note that the water is scalding hot, and the draining hose
and tap will also heat up during draining.
1.
2.
Just draining the tank is not enough, it should also be cleaned thoroughly 2 -4 times a year.
The easiest way to clean the tank is to make a decalcifying solution by mixing 50g of citric acid with one
litre of water. Pour this solution into the water tank and add water up to the max mark (sauna heater
with manual water intake). Select steam function from the control centre and set high humidity and low
temperature (the purpose is to boil the water as soon as possible without unnecessarily heating the sauna
room). Set long enough operating time so that the water has time to boil for about 15 minutes in the
tank (the time selection is not critical, you can turn the sauna heater off after 15 minutes of boiling).
Then drain the water tank and rinse it with clean water. If desired, you can make the cleaning more
effective by brushing the inner surface of the tank with a brush with hard bristles.
4.
3.
min.
5 L
16