Helo FUSION Gebrauchsanweisung Seite 70

Setting the bathing temperature
The next setting is the bathing temperature. The temperature set value display depends on the selected
bathing mode.
Normal sauna: The lower display shows the set bathing temperature. The
value can be freely changed between 5 – 110 °C with the arrow buttons.
When the setting is confirmed, the control centre goes directly to Setting
the bathing time.
Steam sauna: The lower display shows the set bathing temperature.
The upper display shows the maximum humidity setting with the selected
temperature setting. When the bathing temperature is changed, the humidity
setting also chances. Note that the temperature set here affects the humidity
setting set in Setting humidity, the value shown in the upper display cannot be
exceeded.
If the bathing mode is steam sauna and the temperature setting is exceptionally low in contrast to the
humidity setting (e.g. 30°C and 90%), the sauna room may heat up over the set temperature before the
set humidity is achieved.
Setting the humidity
This setting may only be modified when steam sauna is selected for the bathing
mode. Because the humidity setting depends on the temperature, the control
centre defines the maximum value when the temperature setting is set (see
Setting the bathing temperature). This maximum value can no longer be
exceeded here. If you want a higher humidity value, the temperature setting
must be lowered. The humidity value may freely be set within the maximum
limit with the arrow buttons.
Setting the bathing time
The bathing time is set next. The setting can be freely set within the maximum
limit (in a apartment sauna maximum of 6 straight hours). Take into
consideration the heating time, which depends on the size of the sauna room
and the power rating of the sauna heater, when setting the bathing time.
A
1
R
2
A
OK
3
4
A
1
R
2 A
OK
3
4
A
1
R
2 A
OK
3
4
A
1
R
2 A
OK
3
4
11