Herunterladen Inhalt Inhalt Diese Seite drucken

Setting The Remote Control Mode - Helo FUSION Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 89
2.6.5.

Setting the remote control mode

If the sauna heater is equipped with a remote control device, and the remote
control function is activated (see 3.x - Sauna heater remote control),
the control centre can be set in remote control mode.
Setting the remote control mode is only possible when the control centre
is in standby mode and there is no starting request from the remote control
device. If you try to set the control centre to remote control mode when
there is a starting request from the remote control device, an error message
"OPEN RC_S" is shown on the display.
You can move to remote control mode by pressing the "R" button with the
control centre in standby mode. The display will then show the last used quick
selection program (P1..P4) and mode of that program (normal or steam sauna).
The image shows the memory slot 1 selected with normal sauna program.
The desired bathing program can freely be selected by pressing the arrow up
button. The remote control indicator light will flash to indicate that the control
centre is in remote control mode.
When the sauna heater gets a starting request from the remote control device,
the control centre display show the selected quick selection program and the
text "RUN" for a moment, and the sauna heater indicates the received starting
request with a buzzer. After that, the control centre goes to heating mode. If
the starting request is lost, the sauna heater is turned off immediately.
NOTE:
Before setting the remote control mode, make sure that the sauna room is fit for bathing (doors and
windows closed, no extra stuff in the sauna room and near the sauna heater). The person setting the
remote control mode is responsible for the sauna being safe to be turned on remotely. The remote
control mode must be set again after each bathing. This is to make sure, the heating is safe. Possible
power failure will reset the remote control mode, and it must be set again.
A
1
R
2
A
OK
3
4
A
1
R
2
A
OK
3
4
A
1
R
2
A
OK
3
4
13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis