Checking The Bathing Program - Helo FUSION Gebrauchsanweisung

2. When the OK button is pressed again, the hour separator stops
flashing to indicate the clock is stopped and may now be set to
desired time. The setting
is done by pressing either arrow up (+) or arrow down (-) buttons. A
short press will step a minute at a time and a long press will scroll the
number with acceleratingspeed.
3. When the desired time is displayed, confirm the setting by pressing OK. The hour
separator starts flashing to indicate that the clock in running. In 5 seconds the control
centre returns automatically to standby mode.
2.6.3.

Checking the bathing program

Fusion sauna heater control centre is equipped with 4 memory slots which may be programmed with
unique bathing programs. As factory settings the memory slots 1 and 2 are programmed with normal
sauna programs and the slots 3 and 4 with steam sauna programs. It is possible to program a personal
bathing program into the memory slots. These programs are stored in the memory, even if power is cut
off the control centre. Bathing programs can be checked when the control centre is in standby mode.
For more detailed instructions for setting bathing programs, see 2.6.4 - Setting bathing program and -
Saving bathing program. page 12
1. With the control centre in standby mode, press and keep pressed the number of the
memory slot you wish check and keep the button pressed. The upper display shows the
number of the memory slot. Keep the button pressed.
2. After about 2 seconds the display show the set values for that memory slot. The upper
display shows bathing time and the lower display shows bathing temperature. If a steam
sauna program is stored in the memory slot, the lower display shows first the bathing
temperature and then the humidity setting.
3. The indicator light by the display indicate, which value is shown on the display. The
control centre returns to standby mode when the button is released
NOTE: If the memory slot buttons are pressed when the control centre is in use / programming mode,
the sauna heater will turn on immediately with the program stored in that memory slot (see 1.2 - Quick
start of the sauna heater).
A
1
R
2
A
OK
3
4
9