Heating Mode; Drying Mode; Time Setting - Helo FUSION Gebrauchsanweisung

Pre-selection mode:

Heating mode:

Drying mode:

Remote control mode:
2.6.2.

Time setting

If power is cut off for over 30 seconds (either from the sauna heater main switch or due to blackout), the
control centre clock will reset to factory setting (12:00). During shorter cut offs (under 30 seconds),
control centre backup use will keep the clock in time. Checking and setting the time may only be done
when the control centre is in standby mode.
1. With the control centre in basic mode, press the OK button.
The upper display shows the software version and the lower display shows
the time. The hour separator (dot) flashes to indicate that the clock in running.
If no button is pressed within 5 seconds, the control centre returns to standby
mode.
If there is a pre-selection time set in the use / programming mode,
the control centre goes into this mode as soon as the settings are
saved. The following settings may be modified in this mode
• Pre-selection time
The control centre goes into heating mode after the pre-selection
time has expired or when a quick selection is used. The following
settings may be modified in this mode
• Bathing time
• Bathing temperature
• Humidity (only when the bathing mode is steam sauna)
This mode is in use only when the bathing mode is steam sauna. The
control centre goes automatically into this mode as soon as the bathing
time has expired. The drying time is 30 minutes at 90 °C (these settings
can not be modified). The drying mode may be aborted by pressing the
Start / Stop button.
NOTE: If bathing is stopped before the bathing time has expired,
the control centre will not go into drying mode, but directly into
standby mode.
If the sauna heater is equipped with a remote control device, the control
centre may be set in a remote control mode. The sauna heater may then be
remotely started with desired quick selection program. For more information
about remote controlling, see 2.6.5 Setting the remote control mode, and 3.8
Sauna heater remote control.
The following functions are independent of the control centre mode, so they
may be used always
• Lighting controls
• Fan controls
A
1
R
2
A
OK
3
4
8