Quick Instructions For Use Of The Sauna Heater; Check Before Taking A Sauna Bath; Quick Start Of The Sauna Heater - Helo FUSION Gebrauchsanweisung

1.

Quick instructions for use of the sauna heater

1.1

Check before taking a sauna bath

The sauna room is suitable for taking a sauna bath.
The door and the window are closed.
The sauna heater is topped with stones that comply with the manufacturer's recommendations, the
heating elements are covered with stones, and the stones are piled sparsely.
NOTE: Structural clay tiles are not allowed.
1.2

Quick start of the sauna heater

Press the Start button, when the control centre is in standby
mode (display dark). "SET PROG" is displayed and the
control centre goes to use / programming mode and
waits for user's selection.
Select one of the pre-programmes sauna programs with the buttons 1 -4
(memory slot 1 selected in the picture). The factory settings for the memory
slots 1 -4 are as follows:
Memory slot 1: Normal sauna / 80°C / 2 hours
Memory slot 2: Normal sauna / 90°C / 2 hours
Memory slot 3: Steam sauna / 50°C / 60% / 2 hours
Memory slot 4: Steam sauna / 60°C / 38% / 2 hours
Memory slot contents may be reviewed without turning the sauna heater on and the contents may freely
be modified to accommodate user preferences. For more detailed instructions, see 2.6 "Using the sauna
heater control device."
If a sauna heater with manual water intake and a steam sauna program is selected, make sure that there is
enough water in the water tank. Filling the tank is significantly safer when the sauna heater is cold.
Persons with reduced physical and mental capacity, sensory handicap, or little experience and knowledge
about how the device is operated (e.g. children), should only operate the device while supervised or
according to instructions given by the persons in charge of their safety.
Make sure that children aren't playing with the sauna heater.
A
1
R
2 A
OK
3
4
A
1
R
2
A
OK
3
4
3