JVC DT-V21G11 Bedienungsanleitung Seite 21

PICTURE SUB ADJ.
Configure the standard level of image adjustment.
Item Content
CONTRAST * Adjust the standard level for the contrast adjusted with the CONTRAST knob on the
1
front panel.
BRIGHT * Adjust the standard level for the brightness adjusted with the BRIGHT knob on the
1
front panel.
CHROMA * Adjust the standard level for the chroma adjusted with the CHROMA knob on the
1
front panel.
* Adjust the standard level for the phase adjusted with the PHASE knob on the front
PHASE * 1, 2
panel.
NTSC SETUP Select the set-up level of the input NTSC signal.
COMPO. LEVEL Select the level of the analog component signal (480i and 576i only).
sub menu Display the sub menu which enables you to adjust the items in "PICTURE SUB ADJ." while viewing the actual picture.
reset Restore the default settings for all the items in "PICTURE SUB ADJ." (You cannot select items to reset.)
* 1 Memorized for each input.
* 2 When "COMPONENT PHASE" is set to "DISABLE," "PHASE" cannot be adjusted if no NTSC signal is input.
SIZE/POSI. ADJ.
Adjusts the size and position of the picture.
Item Content
H SIZE* Adjust the horizontal picture size. Setting value varies depending on the signals.
1
H POSITION* Adjust the horizontal picture position.
1
V SIZE* Adjust the vertical picture size.
1
V POSITION* Adjust the vertical picture position.
1
sub menu Display the sub menu which enables you to adjust the items of "SIZE/POSI. ADJ." while viewing the actual picture.
reset Restore the default settings for all the items in "SIZE/POSI. ADJ."
* Memorized for each signal format.
1
WHITE BALANCE SET.
Selects the gamma correction value, color temperature and adjusts the drive level and cutoff point of each color (R/G/B).
Item Content
GAMMA Select a gamma correction.
COLOR TEMP. Select the color temperature.
R DRIVE Adjust the drive level of each color (red, green, and blue).
G DRIVE
B DRIVE *
1
R CUT OFF Adjust the cutoff point of each color (red, green, and blue).
G CUT OFF
B CUT OFF *
1
sub menu Display the sub menu which enables you to adjust the items in "WHITE BALANCE SET." while viewing the actual picture.
reset Restore the default settings for the drive levels and cutoff points of the selected color temperature. (You cannot select
items to reset.)
* 1 Memorized for each color temperature
.
Setting value
– 20 – +20
– 20 – +20
– 20 – +20
– 20 – +20
00 (compliant with 0% set-up
signal),7.5 (compliant with 7.5%
set-up signal)
B75 (compliant with BetacamVTR
7.5% set-up signal), B00 (compliant
with BetacamVTR 0% set-up signal),
SMPTE (compliant with M2VTR
signals)
Setting value
Setting value varies
depending on the
signals.
Setting value
2.2 (equivalent to γ2.2), 2.35 (equivalent to γ2.35),
2.45 (equivalent to γ2.45), 2.6 (equivalent to γ2.6)
9300K, 6500K, USER
-255 – 000 (in 256 grades)
-228 – 000 + 227 (in 256 grades)
EN
19