Preparing For Treatment; Starting The Unit - Beurer IL50 Gebrauchsanweisung

Preparing for treatment

Arrange yourself in front of the unit so
you can relax and enjoy the treatment
of the part of the body concerned.
Tilt the lamp so the unit is angled di-
rectly at the part of the body being
treated.
The distance to the infrared radiant
heater depends largely on personal
heat sensitivity and the treatment con-
cerned.
Make sure the distance between the
infrared radiant heater and the part
of the body being treated is not less
than 30 cm!
Do not use the unit for more than 15 min-
utes at a time (risk of overheating). Allow
the unit to cool down before you use it a-
gain.
Treatment duration
We recommend short treatment times at
the beginning. However, even when the
unit is used correctly, the skin of some
people can have an oversensitive or aller-
gic reaction to the heat treatment (e.g. in-
tense redness, blisters, itching, heavy
sweating) .

Starting the unit

Important
Always close or cover your eyes when
radiating the face.
Press the On/Off switch (3)
The unit will turn on automatically after
a short time.
Set the time selector (5) to the desired
duration (1 to 15 minutes).
You can press the time selector (5) dur-
ing operation to reset the treatment du-
ration.
The infrared radiant heater switches off
automatically after the set time.
For an additional treatment, you only
need to press the time selector (5) to
reset your individual treatment time.
Important
Do not touch the hot glass.
To end treatment, use the On/Off switch
(3) and disconnect the power plug.
During treatment
Examine the part of the body treated
frequently and check for skin reactions.
Cease exposure immediately if there
are any signs of oversensitivity or an al-
lergic reaction, and consult a doctor.
The unit can be switched off at any time
using the On/Off switch (3).
Do not cover up or pack the unit away
while it is warm.
After treatment
Switch off the unit at the On/Off switch
(3).
Pull the mains plug out of the socket.
19