Topcom BUTLER 4450 Gebrauchsanweisung Seite 22

Topcom Butler 4450/Twin/Triple/Quattro
Even if the answering machine is Off, it will automatically pick up after 10 rings to enable
remote activation (see 7.3 "Remote Operation" on page 25)
7.1.3 Setting Number of Rings
The number of rings after which the answering machine will answer calls can be set from
2 – 9 and TS (Toll saver). The standard setting is 6 rings. In Toll saver mode, the machine
will answer after 6 rings if there are no new messages, and after 2 rings if there are new
messages. If there are no new messages and you call your machine to check your messages
remotely (see 7.3 "Remote Operation" on page 25), you can hang up after the 2nd ring. You
do not need to pay connection fees and you know that you do not have any new messages.
To set the number of ring by the base:
• To check the actual number of rings, briefly press the 'skip forward'
playback the current number of rings.
• Press for 2 secs to set the number of ringing tones.
• Press immediately
• If you do not press any keys for 3 seconds, the machine will set the selected number of
rings.
To set the number of rings by the handset:
1. Enter the menu by pressing
2. Select TAM SETTINGS using the up
3. Press OK
4. Select ANS DELAY using the up
5. Set the number of rings using the up
7.1.4 Memory Full
If the memory is full, the answering ON/OFF LED will flash on the base rapidly (0,5 sec.
ON/OFF). If the answering machine is turned On and a call comes in, the machine will
automatically play OGM 2 (answering machine function without recorded caller message).
When listening to the messages, the internal voice will announce that the memory is full and
then play back the messages.
Erase some or all the messages after listening to them.The memory is free again.
7.1.5 Programming the VIP Code
The VIP code is a 3-digit code used to operate the machine remotely (see 7.3 "Remote
Operation" on page 25). The VIP code is set to '123' by default.
1. Enter the menu by pressing
2. Select TAM SETTINGS using the up
3. Press OK
4. Select REMOTE CODE and press OK
5. Enter the new code and press OK to confirm
22
to change the current number of rings.
/OK
and down
/OK
and down keys
keys and press OK
and down keys and press OK to confirm.
and down keys
Topcom Butler 4450/Twin/Triple/Quattro
button. A voice will