General Safety Precautions - Hilti DC 125-S Bedienungsanleitung

General safety precautions

(Please read and keep these instructions)
Caution
The following fundamental safety precautions must always be observed when
using electric tools/machines as protection against electric shock, the risk of injury
and fire hazards. Please read and take note of these precautions before you use
the tool/machine. Keep these safety precautions in a safe place!
■
Keep your place of work clean and tidy. Disorder where you are working creates
1
a potential risk of accidents.
■
Make allowance for influence from the surroundings. Don't expose your electric
2
tools/machines to rain. Don't use electric tools/machines in damp or wet surround-
ings. Make sure the work area is well lit. Don't use electric tools/ machines near
inflammable liquids or gases.
■
Always protect yourself against electric shock. Never touch grounding (earthing)
3
parts e.g. pipes, radiators, cookers, ovens, refrigerators.
■
4 Keep children away. Don't let other persons touch the electric tool/machine or
supply cord. Keep them away from your work area.
■
Keep your electric tool/machine in a safe place. Electric tools/machines not in
5
use should be kept in a dry locked-up place out of the reach of children.
■
Don't overload your electric tools / machines. You will do your work better and
6
safer in the specified performance / rating range.
■
Do not use the electric tool for purposes for which it is not intended (e. g. by
7
fitting drill bits or similar, fitting saw blades for woodworking, etc.).
■
Wear suitable clothing. Don't wear loose clothing or jewellery – they could be
8
caught up in moving parts. When working outside, the use of rubber gloves and
non-slip shoes is recommended. Wear a helmet or cap if you have long hair.
■
Always wear protective goggles. If work causes dust, wear a mask as well.
9
■
Connect dust extraction equipment. If devices are provided for the connection of
1 0
dust extraction and collection facilities ensure these are connected and properly
used.
■
Don't use the supply cord for any other purpose. Don't carry the electric tool/
1 1
machine by the supply cord and don't pull the plug out of the socket/receptacle by
pulling the supply cord. Protect the cable from heat, oil and sharp edges.
■
1 2 Secure the workpiece. Use a clamping device or vice to hold the workpiece. It is
secured more reliably in this way than in your hand and you can then hold and
operate your electric tool/machine with both hands.
■
Don't bend over too far when working. Avoid an unusual stance. Make sure that
1 3
you are standing firmly and keep your balance at all times.
■
Take good care of your electric tools/machines. Keep the drill bits, insert tools
1 4
etc. sharp and clean so that you can do your work better, safer and more reliably.
Observe the cleaning and maintenance regulations and the instructions for chang-
ing drill bits, insert tools etc. Check the supply cord regularly and have it renewed
by a recognized specialist if it is damaged. Check the extension supply cord regular-
ly and, if it is damaged, replace it. Keep grips and side handles dry and free from oil
or grease.
12
Printed: 07.07.2013 | Doc-Nr: PUB / 5069468 / 000 / 00