Ttl Flash Mode - Metz MECABLITZ 58 AF-1 Nikon Bedienungsanleitung

Flash operation with Group A cameras (see table 1)
The flash parameters for ISO, aperture and lens focal length or mirror position
have to be set by hand (see 6). The range indicator on the display matches the
set flash parameters.
Flash operation with Group B, C, D and E cameras (see table 1)
The flash parameters for ISO, aperture and lens focal length or mirror position
are set automatically if the camera transfers the necessary data to the flash unit.
The range indicator on the display of the control unit matches the flash parame-
ters transferred from the camera.
If the camera does not transfer one or more flash parameters to the flash
unit, you will have to adjust these settings by hand (see 6).

5.2 TTL flash mode

The TTL flash mode offers a very simple method of achieving excellent flash
shots. In this mode, exposure readings are taken by a sensor built into the
camera which measures the amount of light through the camera lens (TTL). The
electronic control circuit within the camera transmits a stop signal to the flash
unit after sufficient light has been emitted, instantly interrupting the flash. The
advantage of this flash mode is that all factors influencing correct exposure (fil-
ters, change of aperture and focal length with zoom lenses, extensions for close-
ups, etc.) are automatically taken into account.
TTL flash mode is supported by all modes of camera operation (such as „P" for
fully automatic settings, „A" for aperture priority mode, „S" for shutter priority
mode, vari or scene modes, and „M" for manual mode).
Setting procedure:
• Press the „Mode" button until „Mode" flashes on the LC display.
TTL
• Set the flash mode using the UP
mode you choose is then highlighted. The setting takes effect immediately.
• Press the „Return" button to change the display back to the normal view.
If the „Return" button is not pressed, the display will change back to the
normal view after about 5 seconds.
and DOWN arrows. The flash
Standard TTL flash mode is only supported by cameras in Groups A, B
and C.
D-TTL and I-TTL flash modes
D-TTL and I-TTL flash modes are advanced variants of the normal TTL flash
modes used with analog cameras. These modes are supported by Groups D
and E cameras (see table1). Prior to shooting, the flash unit fires a series of
barely visible measuring pre-flashes. The camera evaluates the reflected pre-
flash light so that the subsequent flash exposure is optimally adapted to the pre-
vailing photographic situation (see your camera's operating instructions).
When the TTL flash mode is selected from the „mode menu", the flash unit auto-
matically activates standard TTL, D-TTL or i-TTL flash mode, depending on the
type of camera (see tables 1 and 2). After the settings are confirmed,
will appear in the flash unit display for D-TTL or i-TTL flash modes.
Setting procedure:
• Press the „Mode" button until „Mode" flashes on the LC display.
TTL
• Set the flash mode using the UP
mode you choose is then highlighted. The setting takes effect immediately.
• Press the „Return" button to change the display back to the normal view.
If the „Return" button is not pressed, the display will change back to the
normal view after about 5 seconds.
If the shot was properly lit, the correct exposure indication
about 3 seconds (see 13).
To test the TTL function with analog cameras, a roll of film has to be in
the camera. Please note whether there are limitations for your camera in
terms of film sensitivity or ISO (i.e., maximum ISO 1000) for TTL flash
operation (see your camera's operating instructions).
TTL
and DOWN arrows. The flash
will flash „OK" for
95