Before First Use; Daily Use; Loading The Laundry; Filling The Detergent And Additives - Electrolux WAGLES7000 Benutzerinformation

16 www.electrolux.com
To drain the water refer to
"Draining water out after end
of cycle".
8.8 Temp.
Set this option to change the default
temperature.

9. BEFORE FIRST USE

1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Put a small quantity of detergent in the
compartment for washing phase.
4. Set and start a programme for cotton
at the highest temperature without
laundry.

10. DAILY USE

10.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Press button Ein/Aus - Marche/Arrêt
to activate the appliance.
A short tune sounds.

10.2 Loading the laundry

1. Open the appliance door.
2. Put the laundry in the drum, one item
at a time.
3. Shake the items before you put them
in the appliance.
Make sure you do not put too much
laundry in the drum.
4. Close the door firmly.
Indicator = cold water.
The display shows the set temperature.
This removes all possible dirt from the
drum and the tub.
CAUTION!
Make sure that no laundry
becomes trapped between
the seal and the door. There
is a risk of water leakage or
damage to the laundry.
10.3 Filling the detergent and
additives
Compartment for prewash phase an
soak programme.
Compartment for washing phase.
Compartment for liquid additives
(fabric conditioner, starch).
Maximum level for quantity of liquid
additives.