Before First Use; Preparing For Use - Philips XU3000/02 Bedienungsanleitung

English
8

Before first use

Preparing for use

0.5m
0.5m
1.5m
11 Release button of the water tank
12 Water tank
13 Brush cover
14 Main brush
15 Power on/off switch
16 Front caster wheel
17 Anti-drop sensor (3x)
18 Charging contact points (robot)
19 Sensor to guide the robot back to the station (3x)
20 Side brush
21 Main wheels
22 Mop pad holder
23 Washable mop pad (2x)
24 Indicator light
25 (Charging) station
26 Power cord socket
27 Charging contact points (station)
28 Placemat
29 Adapter
30 Brush cleaning tool
1 Take the appliance out of the box and remove all packaging.
2 Remove the protection covers.
3 If you see any sign of visible damage, go to www.philips.com/support or
contact the Consumer Care Center in your country.
Tips for choosing the best location for installing the station:
-
Do not place the station in bright sunlight or under furniture. This will block
the infrared signal that helps the robot find its way back to the station.
-
Install the station on a level surface against a wall.
-
Install the station on a hard floor.
-
Do not place the station near stairs or a heating source (radiator).
-
Install in a location with good WiFi coverage.
Install the station
1 Install the station within the correct dimensions for placement.
Note: Keep 0.5 meters of space on the sides of the station and 1.5 meters
in front of the station.
2 Connect the station to the power supply.
3 Make sure that the remaining part of the power cable is well concealed
behind the station so that the robot cannot drive over it.
Install the mop pad holder and washable mop pad