Device Elements; Start Up; Dry Vacuum Cleaning; Operation - Kärcher NT 14-1 ECO Betriebsanleitung

Device elements

1 Filter cover
2 Flat fold filter
3 Suction hose
4 Cable hook, rotating
5 Suction head lock
6 Wheel
7 Chassis
8 Dirt receptacle
9 Steering roller
10 Suction support
11 Chassis lock
12 Floor nozzle
13 Suction tube
14 Main switch
15 Carrying handle
16 Suction head
17 Electrodes
18 Filter frame lock
19 Filter frame
20 Bender
21 Exhaust filter
22 Suction pipe storage
23 Elbow intake
24 Crevice nozzle storage
25 Exhaust air outlet
26 Power cord
27 Nameplate

Dry vacuum cleaning

Caution
The flat pleated filter must must always be
in place while vacuuming.
To vacuum fine dust, you can also use
–
an additional paper filter bag or a fleece
filter bag.
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
 Place the paper or fleece filter bag.
 Insert and lock the suction head.
12

Start up

Wet vacuum cleaning
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
To vacuum wet dirt, first remove the pa-
–
per or fleece filter bag.
General
Caution
The flat pleated filter must must always be
in place while vacuuming.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the
–
electrodes with a brush. Clean the con-
tainer with a damp rag and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
Turning on the Appliance
 Plug in the main plug.
 Switch on the appliance at the main
switch.
– 2
EN

Operation