Device Elements - Kärcher NT 27/1 Adv Bedienungsanleitung

Device elements

1 Nameplate
2 Power cord
3 Holder for suction pipes
4 Holder for crevice nozzle
5 Suction hose
6 Suction head lock
7 Steering roller
8 Dirt receptacle
9 Suction support
10 Floor nozzle (Adv only)
11 Floor nozzle (not Adv)
12 Suction tube
13 Main switch
14 Suction head
15 Carrying handle
16 Cable hook
17 Bender
18 Cartridge filter
19 Fastening nut
20 Float
Dry vacuum cleaning
ATTENTION
Risk of damage! For dry vacuuming, the
cartridge filter must always be installed.
– To vacuum fine dust, you can also use
an additional paper filter bag.
Inserting the paper filter bag
Illustration
Illustration
 Release and remove the suction head.
 Insert the paper filter bag.
 Insert and lock the suction head.
12
Start up
Wet vacuum cleaning
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
– To suck wet dirt, first remove the paper
filter bag.
Installing an additional filter
 Release and remove the suction head.
 Turn the suction basket by 180° and
keep it aside.
 Loosen the mounting nuts
 Remove the cartridge filter.
Illustration
 Insert the fastening nut and tighten it.
 Install the additional filter.
 Insert and lock the suction head.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
Turning on the Appliance
 Plug in the mains plug.
 Switch on the appliance at the main
switch.
Emptying the dirt container
– The vacuum channel is equipped with a
float.
– When the dirt water reaches the highest
permissible level in the container, the
suction power is interrupted.
 Switch off the appliance at the main
switch.
 Empty the dirt container.
– 2
EN
Operation