Transport; Storage; Maintenance And Care; Troubleshooting - Kärcher NT 14-1 ECO Betriebsanleitung

Cleaning areas that are difficult to
access
Illustration
 Press the chassis latches and remove
the vacuum unit.
Illustration
 Clean areas that are difficult to access
or steps.
Turn off the appliance
 Switch off the appliance at the main
switch.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
Storing the Appliance
Illustration
 Store the suction hose, the manifold
and the mains cable as shown in the il-
lustration.
 Place the appliance in a dry room and
secure it from unauthorized use.

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Hold the appliance at the handle and at
the suction pipe to transport it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Storage

Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Exchanging the flat pleated filter
 Open filter door.
 Replace the flat pleated filter.
 Close the filter door, it must lock into
place.
Replace the exhaust filter
 Release and remove the suction head.
 Turn the suction basket by 180° and
keep it aside.
 Unlock the filter frame and remove it.
 Remove the exhaust filter from the filter
frame.
 Insert new exhaust filter into filter frame
as per appliance overview.
 Insert the filter frame so that the X is
pointing toward the outside.
 Let the filter frame lock in.
 Insert and lock the suction head.
Cleaning the electrodes
 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.

Troubleshooting

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Suction turbine does not run
 Check the receptacle and the fuse of
the power supply.
 Check the power cable, the power plug
and electrodes of the device.
 Turn on the appliance.
Suction turbine turns off
 Empty the container.
– 3
EN 13