Symbols On The Appliance; Device Elements; Installation; Startup - Kärcher CV 30/1 Originalbetriebsanleitung

● This device is suitable for commercial use, e.g. in
hotels, schools, hospitals, factories, shops, offices,
and rental companies.

Symbols on the appliance

Setting for long pile carpets
Setting for short pile carpets
Filter status indicator (see "Trouble-
shooting -Remove the blockage")
Identifies the access to the roller brush
in the side section (see "Replacing the
roller brush")
Type plate
Further important device specifications are provided on
the type plate. The type plate is located on the rear of
the device casing.

Device elements

Mains cable
1
Mains power cable connection
2
Suction pipe/suction hose
3
Brush head lock
4
Fibre height selection button
5
Filter cover
6
Filter cover lock
7
Main switch
8
Handle
9
Brush cover rotary lock
10
Side section bow
11
Side section
12
Filter bag lock
13
Filter bag
14
Motor protection filter
15
Filter casing
16
Exhaust filter
17
Suction hose at brush head
18
Handle adjustment
19
Cable hook, rotating
20
Cushion nozzle
21
10
Crevice nozzle
22
"Filter" indicator lamp
23
Indicator tuft
24
Roller brush
25
Install the loose parts for handle provided with the de-
vice before using the device for the first time.
See page 4 for illustrations
Handle with mains power cable
1
Handle metal tube
2
Suction pipe and suction hose
3
1. Open the handle adjustment.
2. Push the metal pipe of the handle into the mount all
the way to the lowest latching position (latches audi-
bly twice).
3. Insert the handle into the metal pipe and latch into
place. Take care to ensure that the mains cable is
not jammed or twisted.
4. Pull the handle to the first (uppermost) latching po-
sition.
5. Close the handle adjustment.
6. Insert the suction hose into the connection nozzle.
7. Insert the suction pipe into the mount on the device
Installing the filter bag
1. Unlock and remove the filter cover.
2. Turn the filter bag lock to the right to unlock.
3. Insert the filter bag and turn the filter bag lock to the
left to lock.
4. Fit and lock the filter cover.
Connecting the mains power cable to the
1. Open the cable holder at the handle.
2. Plug the mains cable provided into the socket on the
device.
3. Secure the plug connection against unintentional
unplugging using the cable holder on the handle.
Use only the mains cable provided and only replace it
with an equivalent cable in the case of damage (see
"Technical data").
Adjusting the height of the handle
The height of the handle is adjustable.
See page 4 for illustrations
1. Open the handle adjustment.
2. Move the handle up or down to set the desired
height.
3. Close the handle adjustment.
Switching on the device
1. Connect the mains plug.
2. Switch on the device at the main switch.
Roller brush operation
1. Adjust the fibre height using the fibre height selec-
tion knob on the brush head.
2. Perform cleaning.
English

Installation

Startup

device

Operation