Before Startup - Kärcher K 85 li Betriebsanleitung

Before Startup

Description of the Appliance
When unpacking the product, make sure that
no accessories are missing and that none of
the package contents have been damaged. If
you detect any transport damages please
contact your dealer.
Note: Please refer to page 2 for figures of the
appliance and the operation.
Illustration
1 Joint at the appliance
2 ON/OFF foot switch
3 Rechargeable battery, detachable
4 Release, battery
5 Charging box
6 Charger with charging status display and
charging cable
7 Charging plug
8 Unlocking mechanism for dirt container
9 Dirt container, detachable
10 Casing
11 Wheels
12 Brush roller, changeable
13 Strut
14 Handle
15 Brush strip, already installed
Remove the brush crank holder and
insert the brush roller
Illustration
When delivered, the brush crank is attached
by a corrugated cardboard piece. Please re-
move this cardboard prior to using the appli-
ance.
Turn the appliance around and pull the
cardboard out.
Insert the brush roller and ensure that it
sits properly.
Install the strut and handle
Illustration
While assembling it, make sure that the strut
parts lock into each other.
Assemble both strut parts.
Mount handle onto crank.
Insert the entire strut with the locking but-
ton into the joint on the appliance.
8
English
Charging/inserting/removing the
battery
Illustration
The battery has not yet been inserted in the
appliance at the time of delivery. Please
charge and insert prior to appliance startup.
Charge the battery
Insert the charger delivered with the appli-
ance into a proper socket.
Insert the charging device plug into the
charging connection on the removed bat-
tery.
If the charging display is illuminated, the
charging process will start.
Note: If the charging display is not illumi-
nated, the battery is still full and does not
need to be charged.
The charging time for an empty battery is
approx. 3.5 hours.
Note: Once the battery is fully charged,
the charging display will turn off.
We recommend unplugging the charging
plug and the charger after the charging
process is complete.
Insert the battery
Insert the battery into the intake until it
locks.
Remove battery
Press the release on the bottom (groove)
and pull the battery out.
Start up
Starting the work
Illustration
Switch on the appliance; press the on/off
foot switch to do so.
Move the appliance forward and back-
ward to clean it.
Use the right side for cleaning close to the
edge.
Note: The appliance is equipped with a total
discharge protection, which will turn off the
appliance after approx. 25 minutes when the
battery becomes low. In such a case you
would need to fully charge the battery.