Cleanmaxx Z 08864 Gebrauchsanleitung Seite 26

not pull out the cable with force up to its maximum length (not further than the red
marking on the cable) in order to prevent damage!
❐ Always switch the device off fi rst and remove the mains plug from the mains socket
before replacing a nozzle or attaching or removing any accessories.
❐ On no account should the device be used to suck up the following:
– Liquids or wet substances (e.g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass
1. Make sure that the accessories are attached correctly to the device (see the „As-
sembly" chapter).
2. Pull the mains cable out of the unit as far as you require, ideally up to the yellow
marking, but not further than the red marking on the cable!
3. Insert the mains plug into a properly installed mains socket that is easily accessible.
4. Press the On/Off switch down to switch on the vacuum cleaner. The
switch can also be turned to adjust the suction strength individually.
5. Guide the nozzle over the surface to be cleaned. The vacuum cleaner can be pulled
along like a sledge during cleaning.
6. Press the On/Off switch down again after you have fi nished vacuum cleaning to
switch off the vacuum cleaner.
7. Pull the mains plug out of the socket, hold the mains cable fi rmly and using your foot,
depress the
„whiplash" effect of the cable, e.g. against your legs.
8. Once you have used the fl oor nozzle, hook it into the bracket on the back of the
device.
9. To ensure optimum performance of the device, you should empty the dust container
and clean all dust fi lters regularly (see the „Cleaning the Device" chapter) after every
use.
button to retract the cable. Holding the mains cable prevents any
Tip: The handle is equipped with an exhaust air
valve. Open this valve (by sliding the cover) to
reduce the suction force when cleaning upholstery
or rugs or light, movable objects.
Normally the exhaust air valve should be closed to
prevent the unnecessary reduction of the suction
force.
26
On / Off