Operating The Device - Cleanmaxx Z 04851 - 7001-INT-2 RoboMop Softbase Gebrauchsanleitung

• Block the path to pieces of furniture that the device only just fi ts under, e. g. with fl ower
pots which are heavy enough that they cannot be knocked over. Also block access to any
stairs or similar hazards to ensure that the device cannot fall down them.

Operating the Device

PLEASE NOTE!
❐ Do not leave the device switched on unattended so that you can intervene if any furniture/
objects get in the way.
❐ When operating the device, close the door of the room in which the device is working.
❐ The device is not suitable for carpets.
❐ If during cleaning something gets stuck in the mop frame and impedes the device, switch
the device off immediately and remove the obstacle.
❐ If the device has come into contact with wet surfaces or water, switch it off immediately.
Have the device inspected before further use.
The device can mop up to 60 m² per hour.
2. Place the mop frame in the middle of the room which is to be cleaned.
3. You should now set the cleaning time. To do this, press the ON/TIME button until the
desired time is shown on the display. The following sequence applies here:
– 1 x press
– 2 x press
– 3 x press
4. Once you have selected the cleaning time you want, place the robot ball into the mop
frame. After a few seconds, the device will switch on automatically.
5. Once the cleaning time which is set has elapsed, the device automatically switches itself off.
If you want to switch the device off manually, remove the robot ball from the mop frame,
take hold of the control panel and press the OFF button.
1. Place a fl oor cloth fl at on the fl oor and place the mop frame
on the cloth. Press the mop frame down fi rmly so that the
Velcro fasteners on the bottom of the frame stick to the fl oor
cloth. Make sure that the receptacle and the fl oor cloth fi t
above one another (see illustration).
90 minutes run time
60 minutes run time
30 minutes run time
17
1:30 is shown on the display.
1:00 is shown on the display.
:30 is shown on the display.