Complete Installation - DigiTrace RAYSTAT-CONTROL-10 Bedienungsanleitung

Remark: The sensor cable can be extended up to 150 m when a cross section
2
of 3 x 1,5 mm
sensor cable and sensor extension can be made in junction box JB-86 or
equivalent. Use a shielded cable for extension to avoid interference. The
shielding braid is to be earthed in the thermostat.

5. Complete installation

Put the terminal protection cover back in place.
If RAYSTAT-CONTROL-10 is not yet programmed, please do so as described
in Operational description (page 11) and onwards.
Close the lid of the unit.
Ensure that the pipe and sensor are thermally insulated and clad to the de-
sign specification after installation of thermostat.
Seal cladding with sealant (A).
is used (max. 20 Ω per conductor). The connection between
A
A
A
11