Elsner WS1000 Installation Und Betriebsanleitung Seite 111

•
Open the blind completely until it reaches the stop position and then press
Next
•
Close the blind to where you want it to stop automatically, or press Close
Completely and then press Next.
•
Turn the slats on the blind to the designated position.
Take care to approach the designated position as directly as possible (don't
press the up-key more than 4 times) as many little steps make the
identification of the overall runtime imprecise.
Save your settings with OK or return to setting the tilt method without
saving by pressing Cancel.
With Tilting According to Solar Altitude (according to sun height) set, the
slat angle will be set in steps according to where the sun is. That way, no direct
light enters the conservatory, but visibility to the outside is kept as much as
possible.
Press Adjust to adjust the settings.
•
With Adjust, you reach the runtime settings
•
Open the blind completely until it reaches the stop position and then press
Next
•
Close the blind to where you want it to stop automatically, or press Close
Completely and then press Next.
•
Turn the slats on the blind to a horizontal position.
Take care to approach the horizontal position as directly as possible (don't
press the up-key more than 4 times) as many little steps make the
identification of the overall runtime imprecise.
Save your settings with OK or return to "Tilting According to Solar
Altitude" without saving by pressing Cancel.
•
With Change, you can assign different angles of solar altitude (height of
the sun) to each of the four slat steps:
110
The defaults are
Step2 (open a little) from 15°,
Step3 (almost horizontal) from
30° and
Step4 (horizontal) from 45° solar
altitude. Normally, no direct sun
penetrates in to the room with
these values.