Adjustment Of The Windows - Elsner WS1000 Installation Und Betriebsanleitung

For the automation to react, the values you set must be exceeded or undershot
for the duration of the set delays. This prevents constant retraction and ex-
tension of the awning in rapidly changing lighting conditions. If necessary, the
delay times can be changed as described in the chapter "Delay times for
shading" (p. 137).
If "Outdoor Awning" has been selected in the basic setup (see the chapter
"Basic adjustment of awnings", p. 141), the awning will be retracted upon a rain
or wind alarm independent of the selected settings. For the basic setup "Indoor
Awnings", the wind and rain alarm is deactivated. Blocking temperatures that
are not reached have priority over sun intensity and position.
If there is no DCF reception, and no time has been manually set ("Please set
clock!" appears on the display of the control unit), awnings and blinds will only
be controlled by brightness, indoor temperature etc. The position of the sun will
not be factored in.

Adjustment of the windows

Menu
Setup/Automation Setup/Window
This is where you set the values for the windows auto mode.
There are common settings for all windows:
•
Preiod in which the windows stay closed
and parameters for the automatic mode that are adjusted separately for every
window (or group). The following setup steps are adjusted one after the other:
•
Room air humidity for opening
•
Room temperature for opening (where required with choice of sensor)
•
Outdoor temperature für closing / blocking
•
Forced ventilation period
•
Wind velocity for retraction (wind alarm / wind blocking).
For all windows, you can set a period in which the windows are kept closed.
Press Change to specify a time period. Then set the times using the + and -
buttons and confirm with OK. With Cancel, you return to setting the automatic
window operation without saving.
If multiple drive groups with windows are present, select the individual groups
with Next Window and then proceed as follows:
105