Commissioning And Settings - Storch 266865 ProDist compact Handbuch

Commissioning and settings

Switching the Device On and Off
button. Switches the device and the laser on
hold down the button to switch the device and laser off.
The laser switches off automatically after 30 seconds;
the device after 3 minutes.
Delete values
tap the button. This deletes previously measured values from the
device.
Determining the reference point (figs. of the points)
Measurement is set to the bottom edge of the housing. To change this,
press the reference point button
measuring point (top, bottom).
selection. After switching off the device, it reverts to the factory set-
ting and measures from the bottom edge of the device again.
LCD display lighting
Tapping the
Changing the unit (m, ft. In, ft+in)
Hold down the
button switches the display back-lighting on or off.
button to change the units.
64
, and select another reference
An audible tone confirms your