Error Signals/Troubleshooting - Storch 266865 ProDist compact Handbuch

Error signals / troubleshooting
Error Cause
code
204 Computation error
208 Reception signal
of laser too weak,
distance above 65 m
209 Reception signal of
laser too strong
252 Temperature too high Cool the laser measuring device
253 Temperature too low
255 Hardware error
Remedy
Repeat the last measurement/
measuring procedure
Use an alternative target.
Reflections on the target surface.
Use an alternative target. Reduce
the distance
Warm up the laser measuring
device to the required operating
temperature
Switch the laser measuring device
off and back on. If the error mes-
sage is still shown, contact our
service hotline.
68