Remote Control Handset - T+A M 10 Betriebsanleitung

General
The M10 can be operated using the F10 remote control
handset. It receives its remote control commands via
the R master device (e.g. the P10 pre-amplifier).
LINK
This only works if an R
LINK
the pre-amplifier and the M10.
If the M10 is operated without an R
(manual operation, or powered-on via trigger contact of
the 4-pin XLR socket), then the remote control functions
described here cannot be used.
On the following diagrams all buttons used for the
control of the M10 are marked '
buttons are without function for the M10.
 
 
Switching a 'V' system on and off
To switch the system on, press the 
briefly in order to switch the pre-amplifier on. The M10
is then switched on automatically via the pre-amplifier.
To switch the system off, hold the 
pressed in until all the devices in the 'V' system have
switched to stand-by mode.
The pre-amplifier, integrated amplifier or receiver is the
last device to switch to stand-by mode after about four
seconds.
Note:
If you have switched the machine off using the main
switch on the front panel ("OFF" position), then it can
only be switched on again using this switch, i.e. not
using the remote control system.
   
Switching the loudspeakers on and off
This button switches on or off the loudspeaker outputs
individually.
Remote control of the M10
cable is connected between
connection
LINK
 '. All other  
 button  
 button
 
35

F10