Remote Control - T+A Pa 2500 R Betriebsanleitung

Introduction
In general terms the function of the buttons on the remote control handset is the same as the corresponding buttons on
the machine's front panel.
The following table shows the remote control buttons and their function when operating the machine.

The buttons not required to operate the PA 2500 R are not shown in the illustration of the FM2000.
40

Remote control


Switches the device on and off

Direct source select buttons
The listening sources can be selected directly using the SOURCE

buttons  to. You may need to press the 
...
button twice to select the source IN 6 or IN 7.



A brief press switches the loudspeakers on in turn:
A  B  A+B
A long press switches the loudspeaker outputs off. A brief press
on the  button switches the loudspeakers on again.

Increase / decrease volume
The volume can be increased / decreased in steps by tipping

one of the volume buttons. The current volume level is displayed
on the display screen. If one of the buttons is kept pressed for
approx. 2 seconds
continuously until the button is released.

Navigation

Returns to the previous point / change button

Confirms the input / change button

Selects the previous point within a list / select button

Selects the next point within a list / select button

Confirmation button during input procedures
 

Alpha-numeric input
 Special characters are assigned to the  and 
buttons.

abc
During the text input process it is possible to switch between
...
numerical and alpha-numeric input, and between capital and

lower-case letters, using the  button.
wxyz


During character input:
Switches between numeric and alpha-numeric input, and
between capitals and lower case when pressed (repeatedly)

Opens the configuration menu
(for detail see chapter entitled 'Basic settings of the
PA 2500 HV')

Opens the tone control settings menu
the volume increases /

decreases