Manual Mode - GYS Magys 350-4 Betriebsanleitung

CONTROL PANEL (FIG-4):
Welding mode selection / test ①
2T: two-stage welding / 4T: four-stage welding.
SPOT: Spot welding with adjustable spot diameter
Delay: intermittent welding modes for an optimised
operating procedure
2 modes to make easier the setting up of the welding
unit: « Manual » or « Synergic ».
Test function: The LED switches on when you push
the button①. Read chapter «Welding unit settings»
SPOT / DELAY potentiometer③: To adjust the
welding time of a point, the size of the point and the
time between each point.
Arc dynamics potentiometer
automatically or manually the arc dynamics.
Metal selection and manual mode ⑤: Read chapter
«Welding unit settings»
Mode « Synergic » ⑥: Read chapter «Welding unit
settings»
Wire diameter : Select the wire diameter used.
Thermal protection LED ⑧: Read chapter «Thermal
protection».
WELDING UNIT SETINGS: (FIG-4)
« SYNERGIC » MODE
This function automatically controls the wire speed. There is no need to set the wire speed manually.
Position the potentiometer ② in the middle of the « Optimal synergic » zone
-
Select: Wire type ⑤, wire diameter ⑦, power mode (with the 2 power switches on the front ⑫).
-
From the settings chosen, the unit determines the optimum wire speed and is ready to weld. It is also
possible to manually adjust the wire speed (+ or –) if necessary using the potentiometer
configuration is saved in the memory automatically (wire diameter, wire type, mode).
« Test » function : Only in the synergic mode, I twill indicate you the thickness you can weld with the
parameters selected without using any gas or wire. These values are calculated on the basis of a welding on
the flat surface. Attention: you have current in the torch, so avoid any contact with any metallic part.
NOTE: If the gas, the wire diameter, and the metal used are different from the ones selected in the synergic mode,
you will need to switch to the manual mode to set up the welding unit.
«MANUAL » MODE
To set your device, proceed as follows:
- Choose the welding voltage using the 2 power switches according to the thickness to weld.
- Adjust the wire speed using the potentiometer ②.
Voltage display ⑨: By pulling the trigger (The
LED
be displayed according to the parameters selected.
Power adjustment switch ⑫: 20 positions for the
Magys 350-4, 350 GR and 30 for the 450 WS.
Wire speed setting ②: Potentiometer to adjust the
wire speed. The speed can vary from 1 to 22 m/minute.
Note for the MAGYS 350 GR/450 WS: It is possible to
select either the potentiometer of the separate wire
④
: To adjust
feeder or the generator.
See chapter "wire speed potentiometer" and the sticker
inside the wire feeder.
Welding current display⑩: indicates the amperage
(LED « A ») or
according to the power selected (read « test » function
in the chapter « Welding unit settings »).
Note: « NOP » on the display indicates that the
welding current selected is superior to the one
recommended taking into account the parameters (type
and diameter of the wire).
indicates that your torch is on) the voltage will
the thickness
②.
The last welding
⑪
recommended
12