Specifications - Sharp PG-B10S Anleitung

Specifications

Product type LCD Projector
Model PG-B10S
Video system NTSC3.58/NTSC4.43/PAL/PAL-M/PAL-N/PAL-60/SECAM/
DTV480I/DTV480P/DTV580I/DTV580P/DTV720P/DTV1035I/DTV1080I/
DTV1080I-50
LCD panel × 3, RGB optical shutter method
Display method
Panel size: 0.55" (14.0 mm) (8.5 [H] × 11.2 [W] mm)
LCD panel
No. of dots: 480,000 dots (800 [H] × 600 [V])
1–1.25 × zoom lens, F1.6–1.9, f = 16.8–20.9 mm
Lens
Projection lamp 130 W AC lamp
Component input 15-pin mini D-sub connector
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
signal (INPUT1)
P
P
Horizontal resolution 520 TV lines (DTV720P)
Computer RGB input 15-pin mini D-sub connector
RGB separate/sync on green type analog input: 0–0.7 Vp-p, positive, 75 Ω terminated
signal (INPUT 1)
HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative)
VERTICAL SYNC. SIGNAL: Same as above
S-video input signal 4-pin mini DIN connector
Y (luminance signal): 1.0 Vp-p, sync negative, 75 Ω terminated
(INPUT 2)
C (chrominance signal): Burst 0.286 Vp-p, 75 Ω terminated
RCA connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75 Ω
Video input signal
(INPUT 3) terminated
Computer control signal (RS-232C) 9-pin mini DIN connector
Pixel clock 12–108 MHz
Vertical frequency 43–85 Hz
Horizontal frequency 15–70 kHz
Audio input signal ø3.5 mm minijack: AUDIO, 0.5 Vrms, more than 22 kΩ (stereo)
Audio output 1.0 W (monaural)
2.8 cm round × 1
Speaker system
Rated voltage AC 100–240 V
Input current 1.9 A
Rated frequency 50/60 Hz
Power consumption 185 W (Standard mode)/170 W (Eco mode) with AC 100 V
175 W (Standard mode)/160 W (Eco mode) with AC 240 V
Power consumption (standby) 4 W (AC 100 V) – 6 W (AC 240 V)
Heat dissipation 695 BTU/hour (Standard mode)/640 BTU/hour (Eco mode) with AC 100 V
660 BTU/hour (Standard mode)/600 BTU/hour (Eco mode) with AC 240 V
Operating temperature 41°F to 95°F (+5°C to +35°C)
Storage temperature –4°F to 140°F (–20°C to +60°C)
Cabinet Plastic
I/R carrier frequency 38 kHz
Dimensions (approx.) 11
11
and projecting parts)
Weight (approx.) 6.0 lbs. (2.7 kg)
Supplied accessories Remote control, Two R-6 batteries, Power cord for U.S., Canada etc. (6', 1.8 m), Power cord
for Europe, except U.K. (6', 1.8 m), Power cord for U.K., Hong Kong and Singapore (6', 1.8
m), Power cord for Australia, New Zealand and Oceania (6', 1.8 m), RGB cable (9'10",
3.0 m), Carrying case, Lens cap (attached), Extra air filter, Lens shipping block (attached),
Projector manual and technical reference CD-ROM, "QUICK GUIDE" label, Operation manual
Replacement parts Lamp unit (Lamp/cage module) (BQC-PGB10S//1), Remote control (RRMCGA187WJSA),
Two R-6 batteries ("AA" size, UM/SUM-3, HP-7, or similar), Power cord for U.S., Canada etc.
(QACCDA016WJPZ), Power cord for Europe, except U.K. (QACCVA006WJPZ), Power cord
for U.K., Hong Kong and Singapore (QACCBA015WJPZ), Power cord for Australia, New
Zealand and Oceania (QACCLA005WJPZ), RGB cable (QCNWGA012WJPZ), Carrying case
(GCASNA009WJSA), Lens cap (CCAPHA004WJ01), Air filter (PFILDA010WJZZ), Lens ship-
ping block (SPAKXA333WJZZ), Projector manual and technical reference CD-ROM
(UDSKAA039WJZZ), "QUICK GUIDE" label (TLABZA439WJZZ), Operation manual (TINS-
A917WJZZ)
As a part of policy of continuous improvement, SHARP reserves the right to make design
and specification changes for product improvement without prior notice. The performance
specification figures indicated are nominal values of production units. There may be
some deviations from these values in individual units.
: 0.7 Vp-p, 75 Ω terminated
B
: 0.7 Vp-p, 75 Ω terminated
R
" × 3 " × 8 " (294 (W) × 92 (H) × 222 (D) mm) (main body only)
37 / 5 / 3 /
64 8 4
" × 4 " × 9 " (294.5 (W) × 105.8 (H) × 237 (D) mm) (including adjustment foot
39 / 11 / 11 /
64 64 32
3
PG-B10S